KNIPEX Tungsten carbide electronics diagonal cutters 120 mm Article 77 32 120 H

77 32 120 H Electronics diagonal cutters with inserted carbide cutting edge For extreme demands on cutting pliers due to hard or tough materials, e.g. piano, nickel, tungsten and diode wire, which are increasingly being used in the electronics and aerospace industries. Always the right cutting tool, even for the hardest materials. Precision carbide cutting edges soldered into forged blanks. Sturdy, box joint with no play. Cutting edge hardness of the carbide cutting edges 80 - 83 HRC. Pliers with carbide cutting edges have a significantly longer service life than those with conventional cutting edges. Permanently reliable cutting results due to the prevention of cutting edge deformation caused by overloading. High cost savings due to longer service life of the pliers. pointed head with fillet. with small bevel. - Cutting values medium-hard wire (diameter): Ø 1.0mm - Cutting values hard wire (diameter): Ø 0.6mm - Cutting values piano wire (diameter): Ø 0.2mm - Cutting values soft wire (diameter): Ø 1.6mm - Jaw length (B): 14mm - Jaw thickness (at joint) (D): 7.5mm - Head width (A): 11mm