For detailed information, other images and documents, please select individual articles from the following table.
Products
Application
Zero-point clamping system for clamping with optimised setup time for machining and chipless machining. All with minimal space requirements and a low height.
Execution
- Pneumatic opening.
- Pneumatic blow-out.
- Operating pressure for opening: min. 8 bar to max. 12 bar.
- Operating pressure for re-clamping (turbo): min. 5 bar to max. 6 bar.
- Hardened cover and piston.
- Repeat accuracy less than 0.005 mm.
Notes
The installation clamping module has high retention, pull-in and locking forces. It is opened pneumatically (1) and locked mechanically by spring force. The device must be briefly pneumatically re-clamped (turbo) (2) to achieve the specified pull-in and locking forces. The pressure lines can then be disconnected as desired (module is clamped pressure-free). The installation housing surface serves as the contact surface. It is recommended to use pneumatic pressure booster 6370ZVL. The clamping module with blow-out has three connections: 1x pneumatic opening (1), 1x pneumatic re-clamping (turbo) (2), 1x pneumatic blow-out and support control (3). (Pneumatic blow-out and support control can be optionally connected.) A corresponding installation tool is available under AMF order no. 564855. * Please follow the installation instructions.
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!